The CADE ATP System Competition

Design and Organization

This document contains information about the:

The rules, specifications, and deadlines given here are absolute. Only the competition panel has the right to make exceptions. It is assumed that all entrants have read the web pages related to the competition, and have complied with the competition rules. Non-compliance with the rules could lead to disqualification. A "catch-all" rule is used to deal with any unforeseen circumstances: No cheating is allowed. The panel is allowed to disqualify entrants due to unfairness, and to adjust the competition rules in case of misuse.

Disclaimer

Every effort has been made to organize the competition in a fair and constructive manner. No responsibility is taken if, for one reason or the other, your system does not win.

Changes

The design and procedures of this CASC evolved from those of previous CASCs. Important changes for this CASC are:

Divisions

CASC is divided into divisions according to problem and system characteristics. There are competition divisions in which systems are explicitly ranked, and a demonstration division in which systems demonstrate their abilities without being ranked. Some divisions are further divided into problem categories, which makes it possible to analyse, at a more fine grained level, which systems work well for what types of problems. The problem categories have no effect on the competition rankings, which are made at only the division level.

Competition Divisions

The competition divisions are open to ATP systems that meet the required system properties. Each division uses problems that have certain logical, language, and syntactic characteristics, so that the ATP systems that compete in the division are, in principle, able to attempt all the problems in the division. In the following effectively propositional means that the problem is known to be reducible to a propositional problem, e.g., a CNF problem that has no functions with arity greater than zero. The problems section explains what problems are eligible for use in each division and category. The system evaluation section explains how the systems are ranked in each division.

Demonstration Division

ATP systems that cannot run in the competition divisions for any reason (e.g., the system requires special hardware, or the entrant is an organizer) can be entered into the demonstration division. Demonstration division systems can run on the competition computers, or on computers supplied by the entrant. The entry specifies which competition divisions' problems are to be used. The demonstration division results are presented along with the competition divisions' results, but might not be comparable with those results. The systems are not ranked and no prizes are awarded.

Infrastructure

Computers

The computers have: Each ATP system runs one job on one computer at a time. Systems may use all the cores on the computers (although this does not necessarily help, because a CPU time limit is imposed).

Problems

Problem Selection
Problems for CASC are taken from the TPTP Problem Library. The TPTP version used for CASC is released after the competition has started, so that new problems have not been seen by the entrants.

The problems have to meet certain criteria to be eligible for selection:

The problems used are randomly selected from the eligible problems at the start of the competition, based on a seed supplied by the competition panel.

Number of Problems
The minimal numbers of problems that must be used in each division and category, to ensure sufficient confidence in the competition results, are determined from the numbers of eligible problems in each division and category (the competition organizers have to ensure that there are sufficient computers available to run the ATP systems on this minimal number of problems). The minimal numbers of problems are used in determining the time limits imposed on each solution attempt.

A lower bound on the total number of problems to be used is determined from the number of computers available, the time allocated to the competition, the number of ATP systems to be run on the competition computers over all the divisions, and the time limit per problem, according to the following relationship: 

                   NumberOfComputers * TimeAllocated
NumberOfProblems = ---------------------------------
                     NumberOfATPSystems * TimeLimit
It is a lower bound on the total number of problems because it assumes that every system uses all of the time limit for each problem. Since some solution attempts succeed before the time limit is reached, more problems can be used.

The numbers of problems used in each division and problem category are (roughly) proportional to the numbers of eligible problems, after taking into account the limitation on very similar problems. The numbers of problems used in each division and category are determined according to the judgement of the competition organizers.

Problem Preparation
The problems are in TPTP format, with include directives. The problems in each division are given in increasing order of TPTP difficulty rating.

In order to ensure that no system receives an advantage or disadvantage due to the specific presentation of the problems in the TPTP, the problems are preprocessed to:

In the demonstration division the same problems are used as for the competition divisions, with the same preprocessing applied. However, the original file names can be retained for systems running on computers provided by the entrant.

Resource Limits

CPU and wall clock time limits are imposed. The minimal CPU time limit per problem is 240s. The maximal CPU time limit per problem is determined using the relationship used for determining the number of problems, with the minimal number of problems as the NumberOfProblems. The CPU time limit is chosen as a reasonable value within the range allowed, and is announced at the competition. The wall clock time limit is imposed in addition to the CPU time limit, to limit very high memory usage that causes swapping. The wall clock time limit per problem is double the CPU time limit. An additional memory limit is imposed, depending on the computers' memory. The time limits are imposed individually on each solution attempt.

In the demonstration division, each entrant can choose to use either a CPU or a wall clock time limit, whose value is the CPU time limit of the competition divisions.

System Evaluation

For each ATP system, for each problem, four items of data are recorded: whether or not the problem was solved, the CPU time taken, the wall clock time taken, and whether or not a solution (proof or model) was output.

The systems are ranked in the competition divisions, from the performance data. The THF, TFA, EPR, and UEQ divisions have an assurance ranking class, ranked according to the number of problems solved, but not necessarily accompanied by a proof or model (thus giving only an assurance of the existence of a proof/model). The FOF and FNT divisions have a proof/model ranking class, ranked according to the number of problems solved with an acceptable proof/model output. Ties are broken according to the average time over problems solved. In the competition divisions winners are announced and prizes are awarded.

The competition panel decides whether or not the systems' proofs and models are acceptable for the proof/model ranking classes. The criteria include:

In the assurance ranking classes the ATP systems are not required to output solutions (proofs or models). However, systems that do output solutions are highlighted in the presentation of results.

In addition to the ranking criteria, other measures are made and presented in the results:

At some time after the competition, all high ranking systems in the competition divisions are tested over the entire TPTP. This provides a final check for soundness (see the section on system properties regarding soundness checking before the competition). If a system is found to be unsound during or after the competition, but before the competition report is published, and it cannot be shown that the unsoundness did not manifest itself in the competition, then the system is retrospectively disqualified. At some time after the competition, the proofs and models from the winners of the proof/model ranking classes are checked by the panel. If any of the proofs or models are unacceptable, i.e., they are significantly worse than the samples provided, then that system is retrospectively disqualified. All disqualifications are explained in the competition report.

System Entry

To be entered into CASC, systems must be registered using the CASC system registration form. No registrations are accepted after the registration deadline. For each system entered, an entrant must be nominated to handle all issues (including execution difficulties) arising before and during the competition. The nominated entrant must formally register for CASC. It is not necessary for entrants to physically attend the competition.

Systems can be entered at only the division level, and can be entered into more than one division (a system that is not entered into a competition division is assumed to perform worse than the entered systems, for that type of problem - wimping out is not an option). Entering many similar versions of the same system is deprecated, and entrants may be required to limit the number of system versions that they enter. Systems that rely essentially on running other ATP systems without adding value are deprecated; the competition panel may disallow or move such systems to the demonstration division. The division winners of the previous CASC are automatically entered into their divisions, to provide benchmarks against which progress can be judged.

System Description

A system description must be provided for each ATP system entered, using this HTML schema. The schema has the following sections:

The system description must be emailed to the competition organizers by the system description deadline. The system descriptions, along with information regarding the competition design and procedures, form the proceedings for the competition.

Sample Solutions

For systems in the proof/model classes, representative sample solutions must be emailed to the competition organizers by the sample solutions deadline. Use of the TPTP format for proofs and finite interpretations is encouraged. The competition panel decides whether or not proofs and models are acceptable for the proof/model ranking classes.

Proof samples for proof classes must include a proof for SEU140+2. Model samples for model classes must include models for NLP042+1 and SWV017+1. The sample solutions must illustrate the use of all inference rules. An explanation must be provided for any non-obvious features.

System Requirements

System Properties

Entrants must ensure that their systems execute in a competition-like environment, and have the following properties. Entrants are advised to finalize their installation packages and check these properties well in advance of the system delivery deadline. This gives the competition organizers time to help resolve any difficulties encountered.

Soundness and Completeness

  1. Systems must be sound. At some time before the competition all the systems in the competition divisions are tested for soundness. Non-theorems are submitted to the systems in the THF, TFA, FOF, EPR, and UEQ divisions, and theorems are submitted to the systems in the FNT and EPR divisions. Finding a proof of a non-theorem or a disproof of a theorem indicates unsoundness. If a system fails the soundness testing it must be repaired by the unsoundness repair deadline or be withdrawn. For systems running on computers supplied by the entrant in the demonstration division, the entrant must perform the soundness testing and report the results to the competition organizers.
  2. Systems do not have to be complete in any sense, including calculus, search control, implementation, or resource requirements.
  3. All techniques used must be general purpose, and expected to extend usefully to new unseen problems. The precomputation and storage of information about individual TPTP problems or their solutions is not allowed. Strategies and strategy selection based on individual problems or their solutions are not allowed. If machine learning procedures are used, the learning must ensure that sufficient generalization is obtained so that no there is no specialization to individual problems or their solutions.
  4. The system's performance must be reproducible by running the system again.
Execution
  1. Systems must run on StarExec. (the competition computers). ATP systems that cannot run on the competition computers can be entered into the demonstration division.
  2. Systems must be fully automatic, i.e., all command line switches have to be the same for all problems in each division.
Output
  1. For each problem, the system must output a distinguished string indicating what solution has been found or that no conclusion has been reached. Systems must use the SZS ontology and standards for this. For example
    % SZS status Theorem for SYN075+1
    or
    % SZS status GaveUp for SYN075+1
  2. When outputting proofs/models, the start and end of the proof/model must be delimited by distinguished strings. Systems must use the SZS ontology and standards for this. For example
    % SZS output start CNFRefutation for SYN075+1
  ...
% SZS output end CNFRefutation for SYN075+1
    The string specifying the problem status must be output before the start of a proof/model. Use of the TPTP format for proofs and finite interpretations is encouraged.
Resource Usage
  1. Systems that run on the competition computers must be interruptible by a SIGXCPU signal, so that the CPU time limit can be imposed, and interruptable by a SIGALRM signal, so that the wall clock time limit can be imposed. For systems that create multiple processes, the signal is sent first to the process at the top of the hierarchy, then one second later to all processes in the hierarchy. The default action on receiving these signals is to exit (thus complying with the time limit, as required), but systems may catch the signals and exit of their own accord. If a system runs past a time limit this is noticed in the timing data, and the system is considered to have not solved that problem.
  2. If an ATP system terminates of its own accord, it may not leave any temporary or intermediate output files. If an ATP system is terminated by a SIGXCPU or SIGALRM, it may not leave any temporary or intermediate output files anywhere other than in /tmp.
  3. For practical reasons excessive output from an ATP system is not allowed. A limit, dependent on the disk space available, is imposed on the amount of output that can be produced.

System Delivery

For systems running on the competition computers, entrants must email a StarExec installation package to the competition organizers by the system delivery deadline. The installation package must be a .tgz file containing only the components necessary for running the system (i.e., not including source code, etc.). The entrants must also email a .tgz file containing the source code and any files required for building the StarExec installation package to the competition organizers by the system delivery deadline.

For systems running on entrant supplied computers in the demonstration division, entrants must deliver a source code package to the competition organizers by the start of the competition. The source code package must be a .tgz file containing the system source code.

After the competition all competition division systems' source code is made publicly available on the CASC web site. In the demonstration division, the entrant specifies whether or not the source code is placed on the CASC web site. An open source license is encouraged.

System Execution

Execution of the ATP systems on the competition computers is controlled by StarExec. The jobs are queued onto the computers so that each computer is running one job at a time. All attempts at the Nth problems in all the divisions and categories are started before any attempts at the (N+1)th problems.

A system has solved a problem iff it outputs its termination string within the time limit, and a system has produced a proof/model iff it outputs its end-of-proof/model string within the time limit. The result and timing data is used to generate an HTML file, and a web browser is used to display the results.

The execution of the demonstration division systems is supervised by their entrants.

System Checks